Audio Research VS 110

100 watts per channel continuous from 20Hz to 20kHz. 1kHz total harmonic distortion typically 0.5% at 100 watts, below .05% at 1 watt. Approximate actual power available at “clipping”: 120 watts (1kHz) (Note that the actual RMS power output is dependent upon both line voltage and “condition” ie: if power line has high distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)

(-3dB points) 10Hz to 40kHz

(-3dB points at 1 watt) 0.8 Hz to 40 kHz

1.1V RMS Single-ended for rated output. (28dB gain into 8 ohms)

100K ohms Single-ended

8 ohms, 4 ohms

Approximately 0.9dB 8 ohm load to open circuit

12.7dB

Approximately 11

1kHz total harmonic distortion typically 0.5% at 100 watts, below .05% at 1 watt

6 V/µs

10 µs

Less than 0.2mV RMS – 103dB below rated output (IHF weighted, input shorted)

Approximately 332 joules

105-125VAC 60Hz (210-250VAC 50Hz) 620 watts at rated output, 900 watts maximum, 400 watts at “idle”

(4 matched pairs) 6550EH power output, (5) 6N1P input and driver

Output polarity: Non-inverting. Voltmeter test points for bias. 12 VDC in/out trigger. Detachable 14 gauge AC line cord with IEC socket.

17½” (44.5 cm) W x 7.9″ (20.1 cm) H x 19″ (48.3 cm) D. Rear connectors extend .88″ beyond chassis

61 lbs. (27.7 kg) Net; 69 lbs. (31.4 kg) Shipping.